The hydraulic puller of the gear of the traction motor of the locomotive

Product Name: Hydraulic puller

Designation: SG 004

Purpose: the pressing of gears from the shafts of traction motors.

The connecting thread is G ¾. (or M27 x 2 with a length of 25 mm)

The pressure developed in the puller cylinder is 50 MPa (500 kgf / cm2).

Working fluid: industrial oil I-20A GOST 20799-88.

Overall dimensions, mm:

length .................................... 135

width…………………. 50

height without pump ......... 75

height with pump ......... 240

To fill the feeder, unscrew it from the stripper. Immerse the tip of the feeder in the oil and pull the piston to its extreme position.

Rotate the feeder with the tip upwards and gently push the ball of the tip into the inside to release the air that has fallen into the oil.

Screw the puller into the central hole of the shaft, from which it is necessary to press the pinion and tighten it.

Feeder screw into the body of the puller.

To remove the gears, inject oil into the gearing area of the gear with the shaft until the oil seeps onto the end face.

Package Included:

Hydraulic puller СГ 004 ............ 1 шт.

Passport ................ ..................... .. ... .. 1 pc.